Loading...
2 results
Search Results
Now showing 1 - 2 of 2
- Microplastics reduce microalgal biomass by decreasing single-cell weight: the barrier towards implementation at scalePublication . Mendonça, Ivana; Cunha, César; Kaufmann, Manfred; Faria, Marisa; Cordeiro, NereidaMicroplastics (MPs) are a widespread environmental threat, especially to aquatic and urban systems. Water quality is vital for biomass production in microalgal-based industries. Here, industrially relevant microalgae Tetraselmis suecica, Scenedesmus armatus, and Nannochloropsis gaditana were exposed to PS- and PE-MPs (polystyrene and polyethylene, re spectively – 10-20 μm) contaminated waters (5 and 10 mg/L). Following industrial empirical and ecotoxicological pro cedures, the production period was established as four days (exponential growth phase). 27-long day experiments were conducted to determine the chronic effects of MPs contamination in microalgal biomass yields. MPs induced different responses in cell density: T. suecica decreased (up to 11 %); S. armatus showed no changes; and N. gaditana increased (up to 6 %). However, all three microalgae exhibited significant decreases in biomass production (up to 24, 48, and 52 %, respectively). S. armatus exposed to PS-MPs and N. gaditana exposed to PE-MPs were the most im pacted regarding biomass production. The decrease in biomass yield was due to the reduction in single-cell weight (up to 14, 47, and 43 %), and/or the production of smaller-sized cells (T. suecica). In response to chronic exposure, microalgae showed signs of cell density adaptation. Despite cell density normalizing, biomass production was still re duced compared to biomass production in clean water. Computational modelling highlighted that MPs exposure had a concentration-dependent negative impact on microalgae biomass. The models allow the evaluation of the systematic risks that MPs impose in microalgal-based industries and stimulate actions towards implementing systems to contain/ eliminate MPs contamination in the waters used in microalgae production.
- The effect of microplastics pollution in microalgal biomass production: a biochemical studyPublication . Cunha, César; Lopes, Joana; Paulo, Jorge; Faria, Marisa; Kaufmann, Manfred; Nogueira, Natacha; Ferreira, Artur; Cordeiro, NereidaMicroplastics (MPs) are widely spread throughout aquatic systems and water bodies. Given that water quality is one of the most important parameters in the microalgal-based industry, it is critical to assess the biochemical impact of short- and long-term exposure to MPs pollution. Here, the microalga Phaeodactylum tricornutum was exposed to water contaminated with 0.5 and 50 mg L-1 of polystyrene (PS) and/or polymethyl methacrylate (PMMA). Results show that the microalgal cultures exposed to lower concentrations of PS displayed a growth enhancement of up to 73% in the first stage (days 3-9) of the exponential growth phase. Surprisingly, and despite the fact that long-term exposure to MPs contamination did not impair microalgal growth, a steep decrease in biomass production (of up to 82%) was observed. The production of photosynthetic pigments was shown to be pH-correlated during the full growth cycle, but cell density-independent in later stages of culturing. The extracellular carbohydrates production exhibited a major decrease during long-term exposure. Still, the production of extracellular proteins was not affected by the presence of MPs. This pilot laboratory-scale study shows that the microalgal exposure to water contaminated with MPs disturbs its biochemical equilibrium in a time-dependent manner, decreasing biomass production. Thus, microalgal industry-related consequences derived from the use of MPs-contaminated water are a plausible possibility.